|
|
.JPG) |
.JPG "Plenty evidence of where the greasy..."){kind=small}
.JPG "I think I will just clean this for..."){kind=small}
.JPG "Next project: seal and bearing. And..."){kind=small}
.JPG "Clean up gear."){kind=small}
.JPG "Cleaned it up with ammonia, rinsed..."){kind=small}
| Wiped, chisled out pot-metal rust, and wire brushed. Lubed splines with silicone grease. The retainer clip holding what I guess is the top of the bearing seal is removed in this picture. The lip that keeps the wire spring retainer is disintegrating, so I rotated it some to find a good spot. Washed one small load of rags in hot water to clean up my mess, and then revisited the shaft at the seal with a clean paper towel. There is some minor seepage. I'll monitor this by pulling the (now easy to do) agitator every time I use the machine. | |
| Total images: 27 | Last update: 7/21/10 4:53 PM | Help | |